I have writ­ten a cou­ple posts about my rasp­ber­ry-pi home server­s. And peo­ple seem to like the cas­es I 3d-print­ed for them.

Well, if you liked them here they are.

For a Rasp­ber­ry pi 3-based serv­er you need:

• The case it­self
• Caps to lock each disk in its slot: 1 and 2
• Cap to lock the pi in its slot

For a Rasp­ber­ry pi 4-based serv­er you need:

• The case it­self
• Caps to lock each disk in its slot: 1 and 2
• Cap to lock the pi in its slot

All these are just the fol­low­ing de­signs from thin­gi­verse slapped to­geth­er:

• Pi 3 sleeve case: here
• Pi 4 sleeve case: here
• HDD case: here

They work bet­ter (or at al­l!) if you use a pow­ered USB hub. There is no room in the case for it, just buy one you like and glue it to the side :-)